Panga Forum
News:

Registration is now back open. Hopefully the new spam software will work !


 
*
Welcome, Guest. Please login or register.
Did you miss your activation email?
November 22, 2017, 06:11:11 AM


Login with username, password and session length


Pages: [1]
  Print  
Author Topic: NEW 26 Angler Panga 2013 reviewed today  (Read 6032 times)
0 Members and 2 Guests are viewing this topic.
Coconut Sunrise
Blue Star Club
Captains Club
********
Posts: 282


View Profile Email
« on: April 10, 2013, 02:56:07 PM »

Well I stopped by LHG marine in Homestead Florida today.    They had a new 26 few things I noted new are as Follows
 
Two Small Stern Livewells under rear seat Port and Starboard ( not that Big in My opinion )
The floor now has a panel to remove for Access to Fuel tank.  Fuel fill is now Port Side more toward Amidships
Console had Larger Door, However door would not open Fully it hit Gunnel at edge.
Console front cooler looks Smaller.
Storage boxes added to front seats port and Starboard.
Rod holders had Drain hoses
LED nav Lights
LHG t-top Cloth.  With support Pipes ON TOP CONSOLE Sad  taking up room for electronics IMHO

NO improved Gutter for stern Drainage !  Sad
The Finish Seemed it had Over spray on it Maybe just needs to be detailed
ANGLER sticker on side Looked CHEAP CHEAP CHEAP
Boat had 200 Verado on it  and trailer 48,500 ( she said she is Selling THEM as fast As SHE gets them and that any power was now avail
MERC, YAMA, Zuki, Etec Honda, 

Maybe I get some Photos up but was Not Impressed enough to Get Phone out of Car to Take them...

Coconut
Logged
Captain Tyler
Administrator
Founding Member
**********
Posts: 1417


View Profile Email
« Reply #1 on: April 10, 2013, 07:33:57 PM »

That sucks to hear that they are missing the details

would love to see some pics though
Logged

Chasin' Hoo
Senior Member
**
Posts: 122



View Profile Email
« Reply #2 on: April 13, 2013, 10:54:03 AM »

Yeah would like to see some pics
Logged

CHASIN' HOO
Coconut Sunrise
Blue Star Club
Captains Club
********
Posts: 282


View Profile Email
« Reply #3 on: April 20, 2013, 08:02:51 PM »

well Went By and Boat was gone I will keep a Look out for another one there
But Have to say Not much different then what we Have.

Coconut
Logged
Double Trouble
Newbie
*
Posts: 8



View Profile Email
« Reply #4 on: May 27, 2013, 07:43:03 PM »

I've been reading your previous posts regarding jack plates. Thank you very much for your information. My motor was installed lower than it should have been. I tried multiple props but my MPG is off I should be getting more. I'm going to install a jack plate next month and go from there. Any suggestions if a manual plate would work ok or would I need the hydraulic type?

I just post a few pics of my Panga under Panga photos. Any feed back would be greatly appreciated. im new to this site didn't know it existed!
Logged
Captain Tyler
Administrator
Founding Member
**********
Posts: 1417


View Profile Email
« Reply #5 on: May 28, 2013, 09:09:29 AM »

A manual plate should work just fine.

However a hydraulic plate will let you be able to fine tune it to become perfect a heck of a lot easier.  Also if you get into some tight water you can raise the entire motor up and still get good propulsion. Apposed to tilting the motor and pushing propulsion at an angle against the boat.
Logged

Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines

Valid XHTML 1.0! Valid CSS! Dilber MC Theme by HarzeM